Del.icio.us Digg Reddit Technorati Furl

ca18detottpulsarmanifold24

Jul 11, 2008

Temporarily fit the throttle body and then test fit the manifold. Note that the KA24DE throttle body slightly contacts the valve cover.

Drill the two indicated holes with the 1/2" drill bit. The rest of the holes are drilled to 3/8".
Remove the valve cover from the intake side and us the angle grinder with grinding wheel and notch the cover where the throttle body made comtact. Note that this metal is thin so don't take too much off. about 1-2 cm should suffice.

This entry was posted on Friday, July 11th, 2008 at 7:40 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.