Del.icio.us Digg Reddit Technorati Furl

ca18detottpulsarmanifold26

Jul 11, 2008

Test fit the manifold and valve cover to make sure you have removed enough material. Then remove the cover 1 more time for additional modification.

Remove the valve cover from the intake side and us the angle grinder with grinding wheel and notch the cover where the throttle body made comtact. Note that this metal is thin so don't take too much off. about 1-2 cm should suffice.
With the valve cover removed, cut this nipple close to its base.

This entry was posted on Friday, July 11th, 2008 at 7:47 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.