Del.icio.us Digg Reddit Technorati Furl

ca18detinlineoilcooler8

Jul 30, 2008

Once clean, reassemble the inline cooler to the filter mount. I used a thin bead of black RTV around each seal to ensure no oil leakage.

After removing the filter stud the cooler housing separates from the filter mount. Once again, clean these parts thoroughly inside and out. You don't want any of the old oil / sludge from the donor car to end up in your motor.
Using a 3/8" to 1/8" adapter, my oil temperatue probe sits snuggly in the side of the housing.

This entry was posted on Wednesday, July 30th, 2008 at 10:33 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.