Del.icio.us Digg Reddit Technorati Furl

ca18detinlineoilcooler9

Jul 30, 2008

Using a 3/8" to 1/8" adapter, my oil temperatue probe sits snuggly in the side of the housing.

Once clean, reassemble the inline cooler to the filter mount. I used a thin bead of black RTV around each seal to ensure no oil leakage.
Since I run a SR20DET flywheel with 200sx starter, I had a few clearance issues with the water lines so I shortened the indicated nipple and then rotated the top of the housing to allow more clearance.

This entry was posted on Wednesday, July 30th, 2008 at 10:34 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.