Del.icio.us Digg Reddit Technorati Furl

mr2scangauge11

Oct 10, 2008

Line the removed piece to the area where the clock was removed on the panel. Make sure that you have the ScanGaugeII back piece aligned in the upright position.

Now pull the back off of the ScanGaugeII.
At this point, starting with a small drill bit, create mounting holes in the ScanGaugeII piece and the dash panel. (NOTE: These holes were created through both pieces at the same time to ensure that the holes remain aligned. The image above was taken afterwards to show how the holes should correspond.)

This entry was posted on Friday, October 10th, 2008 at 8:15 pm and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.