Del.icio.us Digg Reddit Technorati Furl

mr2spyderpowersteering5i

Oct 29, 2008

The edge of the circles are also shaped with the grinder to slide right inside the pipe to for the top and bottom.

Grind all surfaces of the two circles to expose fresh metal.
Drill three small concentric pilot holes into the bottom circle.

This entry was posted on Wednesday, October 29th, 2008 at 7:55 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.