Del.icio.us Digg Reddit Technorati Furl

mr2spyderpowersteering5n

Oct 29, 2008

Weld the four adapters as shown to seal them with the circle.

Flipping the circle over shows the flush fit the adapters form.
The protruding portion of the adapters is then cut off right above the weld.

This entry was posted on Wednesday, October 29th, 2008 at 8:14 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.