Del.icio.us Digg Reddit Technorati Furl

mr2spyderpowersteering5u

Oct 29, 2008

Grind the excess weld off to create a cleaner finish.

The finished circle is then thread to through the pipe and weld in place to serve as the bottom of the vent / surge reservoir.
Cut a 1" x 4 1/2" plate from the 1/4" steel plate. Clean all of the edges by grinding.

This entry was posted on Wednesday, October 29th, 2008 at 8:22 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.