Del.icio.us Digg Reddit Technorati Furl

240sxpart2-21

Jan 2, 2009

The main hoop is marked by laying the tube template and the copper template over the pre-bent piece. Marks are mode to indicate where the bends should start.

I used 3/8" copper pipe as a template for the main hoop.
The rear half of the roll cage installed.

This entry was posted on Friday, January 2nd, 2009 at 7:18 pm and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.