FMIC Install (Comptech Supercharged Honda S2000)
Thursday, January 31st, 2008 Posted in Tech(S2000) | No Comments »Recently project S2000 has enjoyed the addition of a Comptech supercharger to give it a little more ... ooomph. But even with the stage 1 pulley peaking at a paltry 5psi, it became clear rather early that the Comptech ...
Electric Oil Pressure Gauge Install (Honda S2000)
Monday, January 28th, 2008 Posted in Tech(S2000) | No Comments »The oil pressure gauge installed on project S2000 is a Faze electrical unit. This guide will demonstrate how to install the sending unit and assumes that the actual gauge itself is already wired for power. (If you need help with ...
Rear Lower Brace Install (MR2 Spyder / MR-S)
Tuesday, January 22nd, 2008 Posted in Tech (MR2 Spyder) | No Comments »The lower rear braces for the MR2 Spyder are member braces that triangulate the control arms on each side of the rear suspension. These braces connect the frame mounting points of the arms together, effectively reducing the flex under ...
MR2 Spyder Front Lower Chassis Brace Install (Che’s Front Brace)
Wednesday, January 16th, 2008 Posted in Tech (MR2 Spyder) | No Comments »From the factory, the front of the MR2 Spyder has two braces that connect the frame rail on each side to the front cross member on the under side of the car. These two braces (or bars) reduce the ...
Honda S2000 Vacuum/Boost Gauge Install (Faze Electric Gauge)
Monday, January 14th, 2008 Posted in Tech(S2000) | No Comments »A boost gauge is an absolute must on any boosted vehicle. On a turbo charged car it will tell you not only how much boost is being developed but whether or not the boost is spiking, creeping or overrunning ...
Honda S2000 Gauge Pod Install (Pillar Pod)
Friday, January 11th, 2008 Posted in Tech(S2000) | No Comments »To complement project S2000's newly pressurized intake manifold, the addition of a few aftermarket gauges are being added to help keep tabs on the motor. But first, a place is needed to locate the first two gauges ...
TRD Front Strut Tower Brace Install (Toyota MR2 Spyder)
Tuesday, January 8th, 2008 Posted in Tech (MR2 Spyder) | No Comments »The TRD front strut tower brace for the MR2 Spyder is a 5.2 lb, dual tube strut bar that reduces the front chassis flex during cornering. I have had strut tower braces installed on most cars I have owned ...
Honda S2000 Boost and Oil Pressure Gauge Install
Saturday, January 5th, 2008 Posted in Tech(S2000) | No Comments »Coming Soon ...
Honda S2000 High Flow Fuel Pump Install (Walbro 255)
Saturday, January 5th, 2008 Posted in Tech(S2000) | No Comments »Purpose: Consider the fuel pump the heart of the fuel system. It provides a constant supply of fuel to the fuel rail to ensure that the injectors always have enough fuel to work with. However, when the power output ...
Installing the Comptech Stage 1 Centrifugal Supercharger onto the Honda S2000
Thursday, January 3rd, 2008 Posted in Tech(S2000) | No Comments »The following guide walks through the steps that were taken to install the Comptech stage 1 centrifugal supercharger onto project S2000. The "complete" kit came off of another Honda S2000 that was getting traded for a 350Z. As ...