Del.icio.us Digg Reddit Technorati Furl

differentialwelding2

Jun 5, 2008

Disconnect the driveshaft from the companion flange (Circled) and then disconnect the output shafts from the differntial.

Place a jack under the differential taking care not to raise the rear end.
Remove the two indicated bolts from the front of the differential housing.

This entry was posted on Thursday, June 5th, 2008 at 9:29 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.