Del.icio.us Digg Reddit Technorati Furl

mr2scangauge16

Oct 10, 2008

The bolts are then secured with nuts on the back side of the dash panel. The back of the ScanGaugeII is now firmly attached to the panel.

I ended up using three holes with small bolts to connect the back of the ScangaugeII to the dash panel.
Once the back of the ScangaugeII and the dash panel are attached, reinstall the circuit board and front plate of the gauge. There will be just enough room to tighten the 4 screws with a small electronics screwdriver.

This entry was posted on Friday, October 10th, 2008 at 8:24 pm and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.