Del.icio.us Digg Reddit Technorati Furl

mr2spyderpowersteering5o

Oct 29, 2008

The protruding portion of the adapters is then cut off right above the weld.

Weld the four adapters as shown to seal them with the circle.
The surface is then ground flat. However, if you look close enough you can see that I may hove gone to far which may result in leaks once everything is installed.

This entry was posted on Wednesday, October 29th, 2008 at 8:16 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.