Del.icio.us Digg Reddit Technorati Furl

mr2spyderpowersteering5q

Oct 29, 2008

To remedy the over grinding, a small weld is placed around all 4 adapters to ensure proper seals.

The surface is then ground flat. However, if you look close enough you can see that I may hove gone to far which may result in leaks once everything is installed.
The new welds are ground down one more time, making sure not to remove too much this time.

This entry was posted on Wednesday, October 29th, 2008 at 8:18 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.