Del.icio.us Digg Reddit Technorati Furl

240sxpart2-13

Dec 18, 2008

The corners are thoroughly sandblasted. This makes quite a mess but is the easiest way to prep the hard to reach corners for welding.

The main roll cage mounts will be placed in these four locations where they will tie into the factory structural rails.
After vacuuming the blast media you can see the clean corner (highlighted).

This entry was posted on Thursday, December 18th, 2008 at 9:18 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.