Del.icio.us Digg Reddit Technorati Furl

240sxpart2-22

Jan 2, 2009

The rear half of the roll cage installed.

The main hoop is marked by laying the tube template and the copper template over the pre-bent piece. Marks are mode to indicate where the bends should start.
The main door bar attached to the roll cage.

This entry was posted on Friday, January 2nd, 2009 at 7:20 pm and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.