Del.icio.us Digg Reddit Technorati Furl

mr2spydershifterbushing7

Sep 15, 2010

The Speed Source bushings are two piece billet aluminum units. Note the bushing to the left with the bolt. When installing the new bushings they should sit as pictured with the tapered ends facing each other. (as these will sandwich the shifter base when installed)

The factory bushings are rubber with steel sleeve inserts.
The tapered edges of each bushing face the plastic shift base on both the top and bottom. The 12mm bolts then secure the base back to the car.

This entry was posted on Wednesday, September 15th, 2010 at 12:12 pm and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.