The 1991 Mazda Miata from which I am building the exo car has led a rough life. This was especially evident when I finished the chassis cleaning in part 5; quite a bit of surface rust was exposed. Usually, I would wait to address the rust during the fabrication process while fitting the roll cage...
Didn’t I mention this may get a little confusing? In part 4, I cleaned up the chassis, removing any remnants attached to the car, cleaning up the cuts, and grinding a few miscellaneous brackets off. Now, I am physically cleaning the chassis to prepare for the final prep and welding. Taking...
The “ghettocet” project keeps growing. That’s not a bad thing but I have quickly realized that a project of this scale is going to take a bit more prep and cleanup than usual before I move on to the roll cage.
I decided to go ahead and remove the subframe from the chassis. This is a pretty straight forward process in the Miata and will give me easier access to everything when I finish the chassis prep and install the roll cage. However, due to my limited work area, I did have to get a little creative.
Exo cars come in all shapes and sizes. This one is an extreme example of what is possible on a limited budget. As such, in part 2, it’s time to get out the cutting tools and get the car chassis down to as low a weight as possible.
In part 1 of the exo car build guide, I disassemble anything that bolts to the Miata. This would be the interior, dash, seats, doors, soft top, and trunk along with anything else that removes semi easily. And where last time I said, ‘this is going to be a lot of fun.’ This time I...
I love junkyard builds and I have always subscribed to the do more with less methodology. So building an exo car is something I have wanted to do for a very long time. It’s also an excuse for me to brush up on some old skills and hone some new ones.
