Welcome to the chassis build of project 240sx. The following photos document the complete gutting and restoration of project 240sx to include roll cage installatio0n as well as painting of the inside, outside and underside of the chassis. Simply scroll…
Related Links Project 240sx Overhaul Journal Index I was able to a make a few last minute installs before heading out to Nopi Drift this weekend. In addition to the new tension rods, new adjustable tie rod ends were installed…
Related Links Project 240sx Overhaul Journal Index The front and rear suspension has been reinstalled with a few new goodies and the trunk is being prepped for the fuel cell. A new battery tray has been installed as well. These…
Unlike the front brace on the MR2 Spyder where the trim had to be cut and the spare tire lid removed, the TRD rear strut tower brace requires no modifications. In fact, a 14mm wrench and about ten minutes is…
This install guide highlights variations for the installation of solid aluminum subframe bushings into the Nissan 240sx. The kit used was purchased from niperformance,org through ebay. The kit includes the bushings, solid rubber inserts (optional) and an install dvd. Although…
The lower rear braces for the MR2 Spyder are member braces that triangulate the control arms on each side of the rear suspension. These braces connect the frame mounting points of the arms together, effectively reducing the flex under corning…
From the factory, the front of the MR2 Spyder has two braces that connect the frame rail on each side to the front cross member on the under side of the car. These two braces (or bars) reduce the flex…
The TRD front strut tower brace for the MR2 Spyder is a 5.2 lb, dual tube strut bar that reduces the front chassis flex during cornering. I have had strut tower braces installed on most cars I have owned and…
The T1R X-brace is a strut tower brace that has a lower x member that ties the tops of the strut towers to the steering rack on the Honda S2000. This brace effectively locks the front of the chassis which…
Installing subframe spacers is an easy mod that will eliminate the wheel hop present in the 240sx. However, it is necessary to place your car on jack stands before beginning. Furthermore, you will need to loosen, but not remove the…
(All items discussed in this entry will have full install walkthroughs posted in the Tech and How To’s page) This car has seen better days and after driving it back from Georgia, it is quite clear that most of the…